In the case of an acute slipped disc, a massage device should not be used on the back until the symptoms have been assessed by a doctor. In the phase that follows, massage can help to relieve the accompanying muscle tension, but it does not affect the disc itself. Understanding this distinction is half the answer.
Show table of contents
What actually happens during a herniation
The intervertebral disc acts as a cushion between two vertebrae. It consists of a firm fibrous ring and a soft core. If the ring tears, tissue from the core protrudes and can press on a nerve root. It is precisely this pressure that causes the typical symptoms.
The intervertebral disc lies deep within the body, protected by the spine and the back muscles. No massage device can reach it, and none can push protruding tissue back into place. What a device can reach is the musculature above it.
Why the muscles still play a role
Around a painful area, the body tenses the muscles to immobilise it. This protective tension is useful, but becomes a problem in itself if it persists for weeks. It restricts movement and causes pain of its own.
This is where massage comes in, and that is why it is a standard component of the rehabilitation phase. It treats the symptom, not the cause. Those who expect this will not be disappointed, but those who expect more will be.
When not to use the device
- During an acute flare-up , whilst the pain is severe and the cause remains unclear.
- If there is numbness in the leg, foot or buttocks.
- In the event of loss of strength , for example if the foot drags whilst walking.
- In the event of bladder or bowel problems. This is a medical emergency and requires immediate medical assessment; massage is not appropriate.
- After an operation , until the treating practice gives its express consent.
How to proceed once clearance has been given
The device is used alongside the spine, never directly on it. The massage heads run along the muscle groups on the left and right, not along the row of bones in the centre. The reason for this is explained in the article Back massager and the spine.
Start with the lowest setting and a short session; five to ten minutes are sufficient to begin with. Heat may be applied; it helps to relieve tension before the mechanical action begins. Suitable devices with finely adjustable intensity settings can be found under Back Massagers. The article Back Massager Test summarises the general factors to consider when making a choice.
How to recognise when to stop
You should stop immediately if the pain increases during use, radiates down into the leg, or if a tingling sensation occurs that wasn’t there before. This applies even if the massage itself feels pleasant. A stimulus that reaches a nerve feels different from muscle work.
Another reason to stop is pain that is worse the following day than it was before. Mild muscle soreness after the first session is normal; an increase in the original symptoms is not. If in doubt, follow the same sequence as at the start: clarify first, then decide.
Sitting is the real problem area
The intervertebral discs are subjected to greater strain when sitting than when standing, particularly when the upper body is bent forwards. For those who spend their working day at a desk, their sitting posture makes a greater difference than any piece of equipment.
In practical terms, this means: sitting upright rather than with a hollow back or a hunched back, feet flat on the floor, and standing up once an hour. A massage device can make these breaks more comfortable, but it is no substitute for them. Combining the two yields greater benefits than using either one alone.
Massage chairs are a case apart
The same precautions apply to massage chairs, with one difference: they operate with significantly more force and also adjust the body’s position. What you need to bear in mind is explained in the article Massage chairs and a slipped disc.
Frequently asked questions
Can you use a massage device if you have a slipped disc?
Not during an acute flare-up, as long as the symptoms have not been assessed by a doctor. Once authorised, a device can help relieve the accompanying muscle tension; it has no effect on the herniated disc itself.
Where should you position the massage device if you have a slipped disc?
Next to the spine, never on it. The massage heads should run along the muscle groups on the left and right. Start on the lowest setting for five to ten minutes.
When should you stop using it?
As soon as the pain increases during use, radiates down the leg or a new tingling sensation occurs. Similarly, if the pain is worse the following day than it was before. Mild muscle soreness after the first session, however, is normal.




Leave a comment
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.