how loud a massage chair really is depends mainly on the programme. When in use, it’s roughly between the noise of a fridge and a quiet conversation; the air compressor is the loudest part. Placing a felt mat under the chair and leaving a bit of space between it and the wall does reduce the noise noticeably.
Show table of contents
Depending on the programme, a massage chair operates at a noise level ranging from that of a fridge to a quiet conversation. You can watch TV next to it, but you can’t have a phone call without it being noticeable. The noise comes from three sources: the air compressor, the roller motors and the track. Here’s what each component causes, which noises are normal and which might indicate a fault.
Where the noise comes from
- The air compressor. The loudest source. It inflates the air cushions on the arms, shoulders, hips and calves. You can hear a steady pumping sound, accompanied by a hissing noise as the air is released. Programmes with a lot of air massage are therefore more audible than programmes focusing solely on the back.
- The roller motors. A low hum that increases in intensity. During tapping programmes, a rhythmic tapping sound is added, which is transmitted through the backrest.
- The rail. A quiet running noise as the roller unit moves up and down the back. With S- and L-shaped rails, you can sometimes hear a brief jolt at the transitions.
- The reclining motor. Only audible when adjusting the backrest, but clearly so.
Then there’s the floor surface. A chair on laminate or tiles sounds louder than the same chair on carpet, because hard floors reflect structure-borne noise.
What is normal and what isn’t
Normal sounds include a steady pumping noise, a hissing sound when air is being released, the hum of the motors, and a click at the end of a programme when the roller unit returns to its starting position.
The following are not normal: grinding or scraping noises that get louder with every movement; a squeak that sounds dry; a cracking sound under load; and a compressor that runs continuously even though no air programme is active. Such noises should be investigated – see Repairing massage chairs.
What you can do about the noise
- Decouple the chair from the floor. A felt mat or a thin rug placed under the chair’s feet will absorb a significant portion of the noise. This is the most effective single measure.
- Move it away from the wall. Sound is reflected back when the chair is placed directly against a wall. A gap of ten to fifteen centimetres is often sufficient.
- Choose the right programme. If you want peace and quiet in the evening, select a back programme rather than a full-body programme with a lot of air.
- Reduce the intensity. The highest setting is also the loudest, and it’s rarely the best.
For details on the best place to position your massage chair, see the article Where to place a massage chair.
When others are asleep in the house
The practical question is usually: Can I still use the chair at 10.00 pm without waking anyone? In a flat with standard walls, this is usually not a problem in the adjoining room, but it’s more likely to be an issue directly below in an older building, as structure-borne noise travels through the ceiling. Anyone planning to do this should factor in the felt mat from the outset.
If you want to avoid any noise at all, you’ll find models without a compressor amongst the smaller massage devices. They’re significantly quieter, but only cover individual zones.
Have a listen before you buy
No product specification sheet provides a reliable indication of noise levels, and decibel figures are of little value without specific measurement conditions. The only reliable test is to listen: start a full-body programme with air massage whilst speaking normally. If you have to raise your voice, you’ll know the score. You can try out the chairs for free at over 40 locations; the models are listed in the overview. The massage chair test shows how the models differ in terms of features.
In a nutshell
- Depending on the programme, a massage chair is somewhere between the noise level of a fridge and a quiet conversation.
- The air compressor is the noisiest, followed by the roller motors and the rail.
- Hard floors amplify the noise; placing a felt mat underneath noticeably reduces it.
- Scraping, dry squeaking and creaking under load are not normal noises.
- The only reliable way to check this is by listening whilst trying out the chair.
Frequently asked questions
Can you use a massage chair in the evening without waking others?
In an adjoining room in a flat with a standard wall, this is usually not a problem. Directly above a bedroom in an older building, however, it’s unlikely to be, as structure-borne noise travels through the ceiling. A felt mat under the chair helps.
How many decibels does a massage chair produce?
There’s hardly any reliable data, as decibel figures mean little without specific measurement conditions. As a guide, depending on the programme, a chair is somewhere between the noise of a fridge and a quiet conversation.
What noises indicate a fault?
Scraping or scratching noises that get louder with every use, a dry squeaking sound, cracking noises under load, and a compressor that runs continuously even when no air programme is selected. Such noises should be investigated.




Leave a comment
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.